GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2006 🢒 Classic 🢒 Vehicle Control Systems 🢒 Vehicle DTC Information 🢒 Inflatable Restraint Sensing and Diagnostic Module Replacement

Removal Procedure

    Caution: Refer to SIR Caution in the Preface section.

    Caution: Do not strike or jolt the inflatable restraint sensing and diagnostic module (SDM). Before applying power to the SDM, make sure that it is securely fastened with the arrow facing toward the front of the vehicle. Failure to observe the correct installation procedure could cause SIR deployment, personal injury, or unnecessary SIR system repairs.

  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Remove the front passenger seat. Refer to Driver and Passenger Seat Replacement.
  3. Remove the passenger front carpet retainer.
  4. Fold back the carpet in order to access the inflatable restraint sensing and diagnostic module (SDM).

    5. Object Number: 241291 Size: MH
  5. Remove the connector position assurance (CPA) (2) from the SDM harness connector (3).
  6. Disconnect the harness connector (3) from the SDM (5).
  7. Remove the SDM mounting fasteners (1).
  8. Remove the SDM (5) from the vehicle.

Installation Procedure
  1. Remove any dirt, grease, or other impurities from the mounting surface.

    2. Object Number: 241291 Size: MH
  2. Install the SDM (5) horizontally to the vehicle.
  3. Point the arrow on the SDM toward the front of the vehicle.

    4. Notice: Refer to Fastener Notice in the Preface section.

  4. Install the SDM mounting fasteners (1).

    5. Tighten
    Tighten the fasteners to 10 N·m (89 lb in).

  5. Install the harness connector (3) to the SDM (5).
  6. Install the CPA (2) to the SDM harness connector.
  7. Position the carpet in order to cover the SDM.
  8. Install the passenger front carpet retainer.
  9. Install the front passenger seat. Refer to Driver and Passenger Seat Replacement.
  10. Enable the SIR system. Refer to SIR Disabling and Enabling .
  11. If you replaced the SDM, perform the following procedure in order to update the BCM with the new SDM part number:

    12.         Important: The AIR BAG indicator may remain ON after the SDM is replaced. After programming the SDM part number into the BCM, cycle the ignition switch OFF and ON. This turns OFF the AIR BAG indicator and clears the DTC.

    11.1. Install a scan tool.
    11.2. Select the Special Functions option from the SIR Menu and press enter.
    11.3. Select the Setup SDM Part Number in BCM option and press enter.
    11.4. Follow the procedure on the scan tool display.
    11.5. Cycle the ignition switch OFF and ON.
  12. Refer to Control Module References for programming and setup information.