GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Chevy Suburban - 4WD 🢒 Engine 🢒 Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L, or 7.0L 🢒 Valve Lifter Oil Filter Replacement

Removal Procedure

    Object Number: 1697098 Size: SH
  1. Remove the intake manifold. Refer to Intake Manifold Replacement.
  2. Disconnect the engine harness electrical connector (1) from the oil pressure sensor.

    3. Object Number: 1509594 Size: SH
  3. Remove the oil pressure sensor (1) and washer (2).
  4. Remove and discard the valve lifter oil filter (3).
  5. Remove and discard the valve lifter oil filter O-ring seal (4).

Installation Procedure

    Object Number: 1509594 Size: SH
  1. Install a NEW valve lifter oil filter O-ring seal (4) into the valve lifter oil manifold.
  2. Install the NEW valve lifter oil filter (3).
  3. Apply sealant GM P/N 12346004 (Canadian P/N 10953480) or equivalent to the threads of the oil pressure sensor.

    4. Caution: Refer to Fastener Caution in the Preface section.

  4. Install the oil pressure sensor washer (2) and sensor (1).

    5. Tighten
    Tighten the sensor to 35 N·m (26 lb ft).


    Object Number: 1697098 Size: SH
  5. Connect the engine harness electrical connector (1) to the oil pressure sensor.
  6. Install the intake manifold. Refer to Intake Manifold Replacement.