Steering Column Accident Damage Inspection - Off Vehicle. Chevrolet Chevy P42 Commercial Chassis 1999

GM Service Manual Online

For 1990-2009 cars only

Makes 🢒 Chevrolet 🢒 1999 🢒 Chevy P42 Commercial Chassis 🢒 Steering 🢒 Steering Wheel and Column - Tilt 🢒 Steering Column Accident Damage Inspection - Off Vehicle

Inspection Procedure

•	Vehicles involved in accidents resulting in frame damage, major body or sheet metal damage, or where the steering column has been impacted, or where supplemental inflatable restraint systems deployed may also have a damaged or misaligned steering column.

•	Check the capsules on the steering column bracket assembly. All capsules must be securely seated in the bracket slots and checked for any loose conditions when pushed or pulled by hand.

•	Observe how the bracket is attached to the jacket assembly.

-	If the capsules are not securely seated and the bracket is bolted to the jacket assembly, replace only the bracket.

-	If the capsules are not securely seated and the bracket is welded to the jacket assembly, replace only the jacket assembly.

•	Check for jacket assembly collapse by measuring the distance from the lower edge of the upper jacket to a defined point on the lower jacket. Replace the jacket assembly if the measured dimensions are not within specifications.

•	Visually inspect the steering shaft for sheared injected plastic. If the steering shaft shows sheared plastic, replace the steering shaft.

•	Any frame damage that could cause a bent steering shaft must have the steering shaft runout checked. Using a dial indicator (1) at the lower end of the steering shaft, rotate the steering wheel. The runout must not exceed 1.60 mm (0.0625 in).