The following information covers the checks and services required to retain the safety, dependability, and emission control performance of the vehicle.

Make sure any necessary repairs are completed on time. Whenever any fluids or lubricants are added to the vehicle, make sure that they are the proper ones. Refer to Fluid and Lubricant Recommendations .

It is important to perform these underhood check at each fuel fill.

Check the engine oil level and add the proper oil if necessary.

In order to select the proper fluids and lubricants, refer to Fluid and Lubricant Recommendations .

Check the engine coolant levels and add the proper coolant mixture, if necessary. Refer to Fluid and Lubricant Recommendations .

Check the windshield washer fluid level in the windshield washer reservoir and add the proper fluid, if necessary. Refer to Fluid and Lubricant Recommendations .

Tire Inflation: Check tire inflation. Make sure the tires are inflated to the pressures specified on the Certification/Tire label located on the driver's door lock pillar. Refer to Vehicle Certification Label .

Key Lock Cylinders: Lubricate the lock cylinders with the recommended lubricant. Refer to Fluid and Lubricant Recommendations .

Body Lubrication: Lubricate all of the following areas:

More frequent lubrication may be required when exposed to a corrosive environment. In order to locate the proper lubricant, refer to Fluid and Lubricant Recommendations .

Starter Switch:

On manual transmission vehicles, put the shift lever in NEUTRAL (N), push the clutch down halfway and try to start the engine. The starter should work only when the clutch is pushed down all the way to the floor. If the starter works when the clutch is not pushed all the way down, the vehicle needs service.

Steering Column Lock:

While parked, and with the parking brake set, try to turn the key to LOCK in each shift lever position.

With an automatic transmission, the key should turn to LOCK only when the shift lever is in PARK (P).

On vehicles with a key release button, try to turn the key to lock without the button. The key should turn to LOCK only with the key button depressed.

Parking Brake and Automatic transmission PARK (P) Mechanism Check.

Caution: When performing this check, the vehicle could begin to move. You or others could be injured and property could be damaged. Make sure there is room in front of the vehicle in case the vehicle begins to roll. Be ready to apply the regular brake at once, should the vehicle begin to move.

Follow this procedure to test the parking brake and automatic transmission PARK mechanism:

1. Park on a fairly steep hill, with the vehicle facing downhill.
2. Keep your foot on the hydraulic brake pedal.
3. Set the parking brake.
4. In order to check the parking brake:

4.1.	Start the engine

4.2.	Place the transmission in NEUTRAL.

4.3.	Slowly remove foot pressure from the hydraulic brake pedal.

5. In order to check the PARK (P) mechanism, follow steps 1-3 above then do the following:

5.1.	Shift to PARK (P).

5.2.	Release all brakes.

Lap and Shoulder Belts Condition and Operation:

Inspect all of the following belt system components:

Replace the belt if the webbing has been cut or otherwise damaged.