Engine Mount Replacement Front

Caution: Before servicing any electrical component, the ignition and start switch must be in the OFF or LOCK position and all electrical loads must be OFF, unless instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal, also disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its components.

1. Disconnect the battery negative cable from the battery. Refer to Battery Cable Replacement .
2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.



3. Inspect the engine mounts. Refer to Engine Mount Inspection .

Notice: When raising or supporting the engine for any reason, do not use a jack under the oil pan, any sheet metal, or the crankshaft pulley. Due to the small clearance between the oil pan and the oil pump screen, jacking against the oil pan may cause the pan to be bent against the pump screen. This will result in a damaged oil pickup unit.

4. Support the engine with a suitable jack. Do not load the engine mounts.



5. Remove the front engine mount through bolt and nut.
6. Raise the front of the engine only enough to permit removal of the engine mount assembly.
7. Remove the front engine mount to bracket bolts, nuts, and washers.
8. Remove the front engine mount assembly.
9. Remove the front engine mount bracket to engine block bolts.
10. Remove the front engine mount bracket.

1. Install the front engine mount to the frame.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the front engine mount assembly bolts, nuts, and washers to the mount bracket..

Tighten
Tighten the nuts to 41 N·m (30 lb ft).




3. Install the engine mount bracket and bolts to the engine block.

Tighten
Tighten the bolts to 47 N·m (35 lb ft).

4. Lower the engine until the front engine mount through bolt can be inserted.
5. Install the engine mount through bolt in the engine mount.
6. Install the front engine mount through bolt and the nut.

Tighten
Tighten the nut to 56 N·m (41 lb ft).

7. Lower the vehicle.
8. Connect the battery negative cable. Refer to Battery Cable Replacement .