Removal Procedure
- Raise the vehicle on a hoist.
- Remove the stabilizer shaft from the following
parts:
| • | The anchor plate mounting nuts (1) |
| • | The anchor plate mounting bolts (9) |
| • | The anchor plate brackets (8) |
- Remove the stabilizer shaft (10) from the anchor plates (3).
- Remove the stabilizer shaft (10) from the following parts:
| • | The frame mounting nuts (13) |
| • | The frame mounting bolts (9) |
- Remove the stabilizer shaft (10) from the frame.
- Remove the insulators from the stabilizer shaft.
Installation Procedure
- Install the insulators to the stabilizer shaft
(10).
- Install the stabilizer shaft (10) to the anchor plates (3).
- Install the brackets (8).
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the stabilizer
shaft to the anchor plate mounting bolts (9).
Tighten
Tighten the stabilizer shaft to the anchor plate mounting bolts to 41 N·m
(39 lb ft).
- Install the washers (5).
- Install the stabilizer shaft to the anchor plate mounting nuts
(1).
Important: Route the parking brake cable over the stabilizer shaft.
- Install the stabilizer shaft to the frame.
- Install the brackets (8).
- Install the stabilizer shaft to the frame mounting bolts (9).
- Install the washers (2).
- Install the stabilizer shaft to the frame mounting nuts (1).
Tighten
Tighten the stabilizer shaft to the frame mounting bolts to 41 N·m
(30 lb ft).
- Lower the vehicle.
