Was the Powertrain On-Board Diagnostic (OBD) System Check performed?

--

Go to Step 2

Go to Powertrain On Board Diagnostic (OBD) System Check

1. Carefully remove the Heated Oxygen Sensor (HO2S).
2. Install the exhaust backpressure tester J 35314-A in place of the HO2S.
3. Start the engine and idle.

Is the reading greater than the specified value?

8.6 kPa (1.25 psi)

Go to Step 4

Go to Step 3

1. Increase the engine speed to the specified value.
2. Observe the backpressure gauge.

Does the reading exceed the specified value?

2000 RPM

20.7 kPa (3 psi)

Go to Step 4

Go to Step 6

1. Check the exhaust system for a collapsed pipe, internal muffler failure, or any kind of heat distress.
2. Repair as necessary. Refer to Exhaust System Inspection in Engine Exhaust.

Was a problem found?

--

Go to Step 6

Go to Step 5

Replace the catalytic converter. Refer to Catalytic Converter Replacement in Engine Exhaust.

Is the action complete?

--

Go to Step 6

--

Operate the vehicle within the conditions under which the original symptom was noted.

Does the system now operate properly?

--

System OK

Go to Step 2