GM Service Manual Online
For 1990-2009 cars only
Table 1: Transmission Scan Tool Data List - 8.1L Gas
Table 2: Transmission Scan Tool Data List - 6.6L Diesel (LLY)

Use the scan tool data list under the following conditions:

    â€¢ The Diagnostic System Check - Vehicle is complete.
    â€¢ The On-Board Diagnostics are functioning properly.
    â€¢ No diagnostic trouble codes (DTCs) are present.

The values below represent a typical display recorded from a properly functioning system.

Important: Do not use a scan tool that displays faulty data. Report the condition to the scan tool manufacturer. The use of a faulty scan tool can result in misdiagnosis and the unnecessary replacement of parts.

Only the parameters listed below are used in this manual for diagnosing. If a scan tool displays other parameters, the values are not recommended by General Motors for use in diagnosis.

Scan tool values below were recorded under the following conditions:

    â€¢ Engine at idle
    â€¢ Upper radiator hose hot
    â€¢ Closed throttle
    â€¢ Transmission in PARK
    â€¢ Closed Loop operation
    â€¢ Accessories OFF
    â€¢ Brake pedal not applied

Transmission Scan Tool Data List - 8.1L Gas

Scan Tool Parameter

Data List*

Units Displayed

Typical Data Value

Clutch Pedal Switch

F0, F6

Applied/Released

Released

Vehicle Speed Sensor

ALL

km/h (mph)

0

*Data List Legend

    â€¢ F0: Engine Data 1
    â€¢ F1: Engine Data 2
    â€¢ F2: Fuel Trim Data
    â€¢ F3: Misfire Data
    â€¢ F4: Enhanced EVAP Data
    â€¢ F5: TAC Data
    â€¢ F6: Cruise Control Data
    â€¢ F7: HO2S Data

Transmission Scan Tool Data List - 6.6L Diesel (LLY)

Scan Tool Parameter

Data List*

Units Displayed

Typical Data Value

Clutch Pedal Switch

F0, F3

Applied/Released

Released

Vehicle Speed Sensor

F0, F2, F3

km/h (mph)

0

*Data List Legend

    â€¢ F0: Engine Data 1
    â€¢ F1: Engine Data 2
    â€¢ F2: Fuel Data
    â€¢ F3: EGR Data
    â€¢ F4: TC Data