Rear D-Ring Replacement Maintenance Body

1. Remove the bolt (1) and nut (2).
2. Remove the D-ring (3) from the bracket.

1. Install the D-ring (3) onto the bracket.

Notice: Refer to Fastener Notice in the Preface section.

Important: D-rings must move once torqued. Do not over torque.

2. Install the bolt (1) and nut (2).

Tighten
Tighten nut and bolt to 200 N·m (148 lb ft).

Rear D-Ring Replacement LSSV

1. Remove the nut and bolt (1).
2. Remove the D-ring from the mount.
3. Discard the wave washer (2).

Important: The flat side of the D-ring must be facing out.

1. Install the D-ring on the bracket.

Notice: Refer to Fastener Notice in the Preface section.

2. Slide the new wave washer (2) between the D-ring and the bracket.
3. Install the D-ring nut and bolt (1). Tighten the nut and bolt until the D-ring will stand straight out on its own.