Spare Tire Carrier Latch Replacement Swing Away

1. Unlatch and open the spare tire carrier swing arm.



2. Remove the bolts (1) securing the latch to the bumper.
3. Remove the latch from the vehicle.

1. Remove the latch mechanism bolts, nuts, and spacers.
2. Remove the latch mechanism.
3. Remove the latch mechanism isolator bolts.
4. Remove the latch mechanism isolator.

1. Check the latch isolator (2) for damage, replace as required.
2. Thoroughly clean the latch casting surfaces and bond the NEW isolator in place using Loctite Black Max 380® adhesive or equivalent.



3. Check for operation and apply Teflon dry lube GM P/N 12371287 (Canadian P/N 10953437) to the latch mechanism (1) as required.

1. Install the latch mechanism isolator, if necessary.

Notice: Refer to Fastener Notice in the Preface section.

2. Install the latch mechanism isolator screws.

Tighten
Tighten the screws to 9 N·m (80 lb in).

3. Install the latch mechanism, if necessary.
4. Install the latch mechanism bolts, spacers, and nuts.

Tighten
Tighten the bolts to 25 N·m (18 lb ft).

1. Install the latch bolts (1) on the bumper. Ensure that the secondary latch cable is also installed and is facing down.
2. Adjust the carrier latch. Refer to Spare Tire Carrier Latch Adjustment .
3. Close and ensure that the spare tire carrier is latched.