For 1990-2009 cars only
Removal Procedure
- Disconnect the negative battery cable.
- Relieve the fuel system pressure. Refer to the Fuel Pressure Relief .
- Drain the fuel tank. Refer to Fuel Tank Draining .
- Remove the fuel tank. Refer to Fuel Tank Replacement .
- Remove the fuel sender assembly. Refer to Fuel Sender Assembly Replacement .
- Note the position of the fuel strainer (2) on the fuel sender.
- Support the fuel sender assembly with one hand and grasp the strainer (2) with the other hand.
- Pull the strainer off the fuel sender. Discard the strainer after inspection.
- Inspect the strainer. Replace a contaminated strainer and clean the fuel tank.
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
Installation Procedure
- Install a new fuel strainer (2) in the same position as noted during disassembly. Push the strainer on the bottom of the fuel sender until the strainer is fully seated.
- Install the fuel sender assembly. Refer to Fuel Sender Assembly Replacement .
- Install the fuel tank. Refer to Fuel Tank Replacement .
- Refill the fuel tank.
- Install the fuel filler cap.
- Connect the negative battery cable.
- Inspect for leaks.
| 7.1. | Turn the ignition ON for 2 seconds. |
| 7.2. | Turn the ignition OFF for 10 seconds. |
| 7.3. | Turn the ignition ON. |
| 7.4. | Check for fuel leaks. |
