For 1990-2009 cars only
Removal Procedure
- Remove the rear seat. Refer to Rear Bench Seat Replacement .
- Release the J clip on the rear of the seat cushion and pull back the trim cover far enough to expose the side bolts (2).
- Remove the cushion side bolts.
- Disconnect the seat pull strap cable (3).
- Remove the cushion from the seat.
- Using a side motion, pull the remainder of the trim cover off the cushion.
- Separate the foam pad from the cushion frame.
Installation Procedure
- Attach the foam pad onto the cushion.
- Carefully pull the trim cover over the cushion.
- Connect the seat pull strap cable (3).
- Before the cover is fully pulled over the frame, install the cushion side bolts (2) in order to attach the seat cushion to the seat.
- Pull the trim cover over the remainder of the cushion.
- Attach the J-clip on the rear of the seat cushion.
- Install the rear seat into the vehicle. Refer to Rear Bench Seat Replacement .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bolts to 35 N·m (26 lb ft).
Ensure proper routing of the seat pull strap cable.
