Tools Required

J 38778 Door Trim Pad and Garnish Clip Remover.

1. Lift the hood.
2. Disconnect the underhood lamp harness.
3. Remove the fastener.
4. Remove the underhood lamp assembly.



5. Use theJ 38778 in order to remove the insulator retainers from the hood.



6. Gently pull on the hood insulator (1) in the center to slide out from behind the holding tabs (4). The insulator has a crease on the hood side to facilitate folding.

1. Position the insulator (1) to the rear hood (3) and fold at the center to position under the front holding tabs (4).



2. Install the retainers (2).
3. Install the underhood lamp assembly.



4. Install the fastener.
5. Connect the harness.
6. Close the hood.