For 1990-2009 cars only
Removal Procedure
- Locate the clutch cylinder on the dash panel in the engine compartment.
- Turn the clutch cylinder 45 degrees clockwise to unlock the clutch cylinder.
- Remove the electrical connector from the clutch pedal position switch.
- Pull the clutch cylinder from the clutch pedal.
- Remove two bolts securing the clutch pedal to the brake pedal support module.
| • | Complete removal of the clutch cylinder from the dash panel is not required. |
| • | Ensure the clutch cylinder rod socket is disconnected from the clutch pedal. |
Installation Procedure
- Secure the clutch pedal to the brake pedal support module with two bolts.
- Push the clutch cylinder rod socket into the clutch pedal bracket square hole.
- Turn the clutch cylinder 45 degrees counterclockwise to lock the clutch cylinder.
- Push the clutch pedal down all the way and release three times to ensure proper clutch pedal operation.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bolts to 50 N·m (38 lb ft).
