1. Loosen the fasteners from the intake manifold sight shield .
2. Remove the sight shield.
3. Disconnect the MAP sensor electrical connector.



4. Remove the MAP sensor from the intake manifold.

Important: Lightly coat the MAP sensor seal with clean engine oil before installing the sensor.

1. Install the MAP sensor. Push the MAP sensor down in order to engage the sensor into the retainer.



2. Connect the MAP sensor electrical connector.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the intake manifold sight shield.

Tighten
Tighten the sight shield fasteners to 10N·m (89 lb in).