Removal Procedure
- Disconnect the negative battery cable.
- Remove the upper fender brace assembly.
- Disconnect the electrical connector at the cruise control module.
- Remove the nuts retaining the cruise control module to the cowl.
- Disconnect the cruise control cable from the module. Refer to Cruise Control Cable Replacement .
- Remove the cruise control module from the vehicle.
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
Installation Procedure
- Install the cruise control module to the vehicle.
- Connect the cruise control cable to the cruise control module. Refer to Cruise Control Cable Replacement .
- Install the nuts in order to retain the cruise control module to the cowl.
- Connect the electrical connector at the cruise control module.
- Install the brace.
- Connect the negative battery cable.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the nuts to 9 N·m (80 lb in).
Tighten
Tighten the bolts to 9 N·m (80 lb in).
