Tools Required

1. Remove the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
2. Remove the front propeller shaft. Refer to Front Propeller Shaft Replacement .
3. Insert a flat-tipped screwdriver into the inner race.
4. Pry the inner race back.



5. Insert a small pry bar into the inner race.



6. Remove the inner part of the seal.



7. Insert a flat-tipped screwdriver or small pry bar in the space between the outer race of the seal and the transfer case.



8. Remove the outer part of the seal.

1. Install the J 43484 (2) to the J 8092 (1).
2. Install the seal onto the J 43484 (2).
3. Using the J 43484 (2) and the J 8092 (1), install the seal.
4. Install the front propeller shaft. Refer to Front Propeller Shaft Replacement .
5. Check the fluid level, add fluid if necessary.
6. Install the transfer case shield, if equipped. Refer to Transfer Case Fluid Replacement .