- Lubricate the switch actuator pivot pin (2).
- Install the switch actuator pivot pin (2) to the windshield wiper and washer switch assembly (1).
- Align the lock housing cover assembly (1) onto the steering column.
- Lubricate the dimmer switch rod actuator (3) with lithium grease.
- Install the dimmer switch rod actuator (3) into the lock housing cover assembly (1).
- Align the dimmer switch rod actuator (3) with the dimmer switch actuator rod.
- Install the column housing cover end cap (2) to the lock housing cover assembly (1).
- Secure the lock housing cover assembly using 3 pan head 6 lobe soc tap screws (1).
- Lubricate the inner race (2) with lithium grease.
- Install the inner race (2) to the steering shaft assembly.
- Install the upper bearing inner race seat (1) to the steering shaft assembly.
- Install the steering column lock cylinder set. Refer to Steering Column Lock Cylinder Set - Assemble - Off Vehicle .
- For standard columns, align the steering column housing assembly (1) onto the steering column.
- Align the dimmer switch actuator rod to the steering column housing assembly.
- Align the ignition switch actuator assembly to the steering column housing assembly.
- Install the steering column housing assembly and secure using 4 hex washer head tapping screws (3).
- Install the thrust washer (2) onto the steering shaft assembly.
- Install the steering column lock cylinder set. Refer to Steering Column Lock Cylinder Set - Assemble - Off Vehicle .
Important: For standard columns, proceed to step 13.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the 3 pan head 6 lobe soc tap screws to 9 N·m
(80 lb in).
Tighten
Tighten the 4 hex washer head tapping screws (3) to 5.5 N·m
(48 lb in).
