Tools Required

1. Remove the universal joint. Refer to Universal Joint Replacement .



2. Remove the yoke nut or bolt and the washers, using the J 3453 .



3. Remove the yoke using the J 7804-A .

1. Ensure that the splines are aligned and the yokes are in phase. Refer to Propeller Shaft Phasing Description .
2. Tap on the yoke in order to ensure that the yoke is completely seated against the propeller shaft.
3. Install the yoke (2).



4. Install the yoke nut or bolt and washers with the 8 nuts mounting. Refer to Fastener Tightening Specifications .
5. Install the universal joint. Refer to Universal Joint Replacement .