For 1990-2009 cars only
Repair Procedure
- Clean the leak area with a solvent.
- Air-dry the area.
- Mix a sufficient amount of epoxy adhesive (GM P/N 1052533 or the equivalent) following the manufacturer's recommendations.
- While the transmission case is hot, apply the epoxy adhesive with a clean, dry soldering acid brush.
- Allow the epoxy adhesive to cure for 3 hours before starting the engine.
- Repeat the fluid leak diagnosis procedures. Refer to Oil Leak Diagnosis .
Caution: Epoxy adhesive may cause skin irritations and eye damage. Read and follow all information on the container label as provided by the manufacturer.
