GM Service Manual Online
For 1990-2009 cars only

    Object Number: 202118  Size: SH
  1. Remove the key from the ignition switch.
  2. Connect the passenger yellow 2-way connector located near the base of the steering column.

  3. Object Number: 202113  Size: SH
  4. Install the Connector Position Assurance (CPA) to the passenger yellow 2-way connector located near the base of the steering column.

  5. Object Number: 202110  Size: SH
  6. Connect the driver yellow 2-way connector located near the base of the steering column.

  7. Object Number: 202105  Size: SH
  8. Install the Connector Position Assurance (CPA) to the driver yellow 2-way connector located near the base of the steering column.
  9. Install the left sound insulator. Refer to Instrument Panel Insulator Replacement in Instrument Panel, Gauges and Console.

  10. Object Number: 202097  Size: SH
  11. Install the AIR BAG fuse to the fuse block.
  12. Install the left IP end cap. Refer to Instrument Panel Outer Trim Cover Replacement in Instrument Panel, Gauges and Console.
  13. Staying well away from both air bags, turn the ignition switch to the RUN position.
  14. 9.1. The AIR BAG warning lamp will flash seven times.
    9.2. The AIR BAG warning lamp will then turn OFF.
  15. Perform the SIR Diagnostic System Check if the AIR BAG warning lamp does not operate as described.