Wheel Speed Sensor Jumper Harness Replacement Front WSS Wiring

1. Raise and support the vehicle on a suitable hoist. Refer to Vehicle Lifting And Jacking in General Information.
2. Remove the connector from the front wheel speed sensor.
3. Remove the harness attaching clips (2) from the control arm (3) and the splash shield (1).
4. Lower the vehicle.
5. Remove the harness attaching clips from the strut tower.
6. Cut the wheel speed sensor wiring circuits within the main engine harness.
7. Strip the insulation on the engine harness leads and the new wheel speed sensor harness leads.

1. Splice the sleeve provided in the jumper harness kit over each engine harness lead.
2. Install the new wheel speed sensor harness leads to the engine harness leads and crimp the connections. Make sure the wire colors match.
3. Heat shrink the tube lightly to seal the connection.
4. Install the harness attaching clip to the strut tower.
5. Raise and support the vehicle. Refer to Vehicle Lifting And Jacking in General Information.
6. Install the harness attaching clips (2) to the control arm (3) and the splash shield (1).
7. Install the connector to the front wheel speed sensor.
8. Lower the vehicle. Refer to Vehicle Lifting And Jacking in General Information.
9. Perform the Diagnostic System Check

Wheel Speed Sensor Jumper Harness Replacement Rear Axle Harness

1. Raise and support the vehicle on a suitable hoist. Refer to Vehicle Lifting and Jacking in General Information.



2. Disconnect the two rear wheel speed sensor electrical connectors (3) from the rear wheel bearing and speed sensor assemblies (2).
3. Disconnect the rear axle harness electrical connector from the body to ABS and fuel sender connector.
4. Remove the rear axle harness retainers (1).
5. Remove the rear axle harness from the vehicle.

1. Install the rear axle harness to the vehicle.
2. Install the rear axle harness retainers (1).
3. Connect the rear axle harness electrical connector to the body to ABS and fuel sender connector.
4. Connect the two rear wheel speed sensor electrical connectors (3) to the rear wheel bearing and speed sensor assemblies (2).
5. Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
6. Perform the Diagnostic System Check