GM Service Manual Online
For 1990-2009 cars only
Makes
🢒
Chevrolet
🢒
2007
🢒
Caprice WM
🢒
Preface
🢒
Cautions and Notices
🢒 Instrument Panel Trim Panel Replacement
Instrument Panel Trim Panel Replacement SWB RHD
Removal Procedure
Using a suitable tool disengage the right hand side trim panel (2) retaining clips and remove the trim panel (2) from the I/P pad (1).
Using a suitable tool disengage the left hand side trim panel (3) retaining clips and remove the trim panel (3) from the I/P pad (1).
Installation Procedure
Align the left hand trim panel (3) with the I/P pad (1).
Install the trim panel (3) by firmly engaging the retaining clips.
Align the right hand trim (2) panel with the I/P pad (1).
Install the trim panel (2) by firmly engaging the retaining clips.
Removal Procedure - (SV6, SS and SSV)
Using a suitable tool disengage the trim panel (1) retaining clips.
Remove the trim panel (1) from the I/P pad.
Installation Procedure
Align the trim panel (1) with the I/P pad.
Install the trim panel (1) to the I/P pad by engaging the retaining clips.
Ensure the trim panel (1) is flush with the I/P pad.
Instrument Panel Trim Panel Replacement SWB LHD
Removal Procedure
Using a suitable tool disengage the right hand side trim panel (2) retaining clips and remove the trim panel from the I/P pad (1).
Using a suitable tool disengage the left hand side trim panel (3) retaining clips and remove the trim panel from the I/P pad (1).
Installation Procedure
Align the left hand trim panel (3) with the I/P pad (1).
Install the left hand trim panel (3) by firmly engaging the retaining clips.
Align the right hand trim (2) panel with the I/P pad (1).
Install the trim panel (2) by firmly engaging the retaining clips.
Instrument Panel Trim Panel Replacement LWB RHD
Removal Procedure
Notice:
Refer to
General Repair Instructions
in the Preface section.
Using a suitable tool disengage the trim panel (1) retaining clips.
Remove the trim panel.
Installation Procedure
Align the trim panel (1) with the I/P pad.
Install the trim panel (1) to the I/P pad by engaging the retaining clips.
Ensure the trim panel (1) is flush with the I/P pad.