Horn Switch Replacement - On Vehicle Chevrolet

Caution: Refer to SIR Handling Caution in the Preface section.

1. Remove the inflatable restraint steering wheel module (4).
2. Remove the screw (3) from the ground lead.
3. Disconnect the power lead (8) by pulling straight out.

1. Install the horn switch (2) to the inflatable restraint steering wheel module (4).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the screw (3) to the ground lead.

Tighten
Tighten the bolt/screw (3) to 1.9 N·m (17 lb in).

3. Connect the power lead (8) by pushing straight into the outlet.

Horn Switch Replacement - On Vehicle Pontiac

Caution: Refer to SIR Handling Caution in the Preface section.

1. Disconnect the horn wiring connector (1) from the steering column.
2. Remove the horn wiring connector bolts (2).
3. Remove the horn switch (3) from the steering wheel (4).

1. Position the horn switch (3) to the steering wheel (4).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the horn wiring connector bolts (2).

Tighten
Tighten the horn wiring connector bolts (2) to 1.9 N·m (17 lb in).

3. Connect the horn wiring connector (1) to the steering column.