You may reattach a rear defogger bus bar lead wire or a
terminal by soldering. Use a solder containing the following items:
- Before soldering the bus bar, buff the repair area using a fine
steel wool. This removes the oxide coating formed during the window manufacture.
- Coat the soldering iron tip with solder before you begin soldering.
Use only enough heat in order to complete the following operations:
| • | Ensure a complete repair |
- Use a brush in order to apply the paste-type flux in small quantities
to the wire lead and bus bar repair area.
- Do not overheat the wire when soldering the wire to the bus bar.
