GM Service Manual Online
For 1990-2009 cars only
Makes
🢒
Chevrolet
🢒
2000
🢒
Camaro
🢒
Engine
🢒
Engine Controls - 3.8L
🢒 Fuel Tank Pressure Sensor Replacement
Removal Procedure
Relieve the fuel system pressure. Refer to
Fuel Pressure Relief
.
Drain fuel tank. Refer to
Fuel Tank Draining
.
Raise the vehicle. Go to
Lifting and Jacking the Vehicle
in General Information.
Remove the fuel tank. Refer to
Fuel Tank Replacement
.
Remove the electrical connector from the fuel tank pressure sensor.
Remove the fuel tank pressure sensor (10) from the modular fuel sender.
Installation Procedure
Install the new fuel tank pressure sensor (10) to the modular fuel sender.
Connect the electrical connector to the fuel tank pressure sensor.
Reinstall the fuel tank. Refer to
Fuel Tank Replacement
.
Refill the fuel tank.
Reconnect the negative battery cable. Refer to
Battery Negative Cable Disconnection and Connection
in Engine Electrical.
Inspect for fuel leaks.
6.1.
Turn ON the ignition for 2 seconds.
6.2.
Turn OFF the ignition for 10 seconds.
6.3.
Turn ON the ignition .
6.4.
Check for fuel leaks.