Step
| Action
| Normal Result(s)
| Abnormal Result(s)*
|
Important: Disconnect the aftermarket equipment and test the system again if both
of the following conditions exist:
• | Aftermarket equipment is installed on any circuit(s) that is designated
for the retained accessory power (RAP) system. |
• | A problem exists with the RAP system operation. |
The following conditions must exist before you begin the following diagnostic
steps:
• | The related fuses are good. |
• | The windows circuit breaker is good. |
|
1
|
- Turn the ignition switch to the ACCY position or the RUN position.
- Turn the ignition to the OFF position.
- Open either the driver door or the passenger door.
| The following equipment does not operate:
• | The rear fog lamps (Export) |
|
Retained Accessory Power (RAP) On After Timeout
|
2
|
- Close the doors.
- Turn the ignition switch to the ACCY position or the RUN position.
- Turn the ignition switch to the OFF position.
- Attempt to operate the following equipment:
• | The rear fog lamps (Export) |
| The following equipment operates for approximately 10 minutes:
• | The rear fog lamps (Export) |
|
|
3
|
- Turn the ignition switch to the RUN position.
- Turn the ignition switch to the OFF position.
- Open either the driver door or the passenger door.
- Attempt to operate the following equipment:
• | The rear fog lamps (Export) |
| The following equipment is disabled immediately when a door is opened:
• | The rear fog lamps (Export) |
|
|
4
|
- Close the doors.
- Attempt to operate the following equipment:
• | The rear fog lamps (Export) |
| The following equipment remains disabled when the doors are closed:
• | The rear fog lamps (Export) |
|
Retained Accessory Power (RAP) On After Timeout
|