For 1990-2009 cars only
Removal Procedure
- Disable the SIR System. Refer to Disabling the SIR System .
- Remove the radio. Refer to Radio Replacement .
- Remove the I/P storage compartment door. Refer to Instrument Panel Compartment Door Replacement .
- Remove the bolts (4) that retain inflatable restraint I/P module to the I/P.
- Remove the nuts (5) from the studs (1) on the I/P module.
- Remove the inflatable restraint module (2) from the I/P (3).
- Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping .
Installation Procedure
- Install the inflatable restraint module (2) to the I/P (3).
- Install the bolts (4) that retain inflatable restraint module to the I/P.
- Install the nuts (5) to the studs (1) to retain the I/P module to the I/P.
- Install the radio. Refer to Radio Replacement .
- Install the I/P storage compartment door. Refer to Instrument Panel Compartment Door Replacement .
- Enable the SIR System. Refer to Enabling the SIR System .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bolts to 8 N·m (71 lb in).
Tighten
Tighten the nuts to 8 N·m (71 lb in).
