Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you perform the Power Door Systems Diagnostic System Check? | -- | Go to Step 2 | |
2 | Verify that the rear power door locks switch is inoperative. Does the power door lock switch operate normally? | -- | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
3 |
Does the test lamp light? | -- | Go to Step 4 | Go to Step 6 |
4 | Connect a 3A fused jumper wire between terminal D, CKT 840 (ORN) and terminal A, CKT 195 (LT BLU) of the endgate lock cylinder switch connector. Do the doors LOCK? | -- | Go to Step 5 | Go to Step 7 |
5 | Connect a 3A fused jumper wire between terminal D, CKT 840 (ORN) and terminal B, CKT 194 (WHT) of the endgate lock cylinder connector. Do the doors UNLOCK? | -- | Go to Step 9 | Go to Step 8 |
6 | Repair an open in CKT 840 (ORN). Refer to Wiring Repairs in Wiring Systems. Is the repair complete? | -- | Go to Step 10 | -- |
7 | Repair the open in CKT 195 (LT BLU). Refer to Wiring Repairs in Wiring Systems. Is the repair complete? | -- | Go to Step 10 | -- |
8 | Repair the open in CKT 194 (WHT). Refer to Wiring Repairs in Wiring Systems. Is the repair complete? | -- | Go to Step 10 | -- |
9 | Replace the endgate lock cylinder switch. Refer to Endgate Lock Cylinder Replacement in Body Rear End. Is the repair complete? | -- | Go to Step 10 | -- |
10 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK | Go to Step 3 |
