GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2000 🢒 Blazer - 4WD - RHD 🢒 Body and Accessories 🢒 Instrument Panel, Gauges, and Console 🢒 Front Floor Console Replacement

Removal Procedure
  1. Remove the shift control lever. Refer to Shift Lever in Manual Transmission.
  2. Remove the cup holder insert.
  3. Remove the screws that retain the trim plate to the console.
  4. Remove the trim plate from the console.
  5. Open the storage compartment cover.
  6. Remove the storage compartment.
  7. Remove the nuts that retain the console to the vehicle.
  8. Remove the electrical connector, if equipped.

    9. Object Number: 303465 Size: SH
  9. Remove the console from the vehicle.

Installation Procedure

    Object Number: 303465 Size: SH
  1. Install the console to the vehicle.
  2. Install the electrical connector, if equipped.

    3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the nuts that retain the console to the vehicle.

    4. Tighten
    Tighten the nuts to 10 N·m (88 lb in).

  4. Install the storage compartment to the vehicle.
  5. Install the trim plate to the console.
  6. Install the screws that retain the trim plate to the console.

    7. Tighten
    Tighten the nuts to 1.9 N·m (17 lb in).

  7. Install the cup holder insert.
  8. Install the shift control lever. Refer to Shift Lever in Manual Transmission.