The front foglamps can be adjusted by turning the adjustment screws.

The adjustment thumb screw is located on the top inboard corner of the foglamp.

Use the following guidelines in order to adjust the aim:

The front foglamps may be adjusted using the screen method. Refer to Headlamp Aiming for information on setting up an aiming screen.

Use the following procedure in order to aim the foglamps using the screen method:

1. Position the vehicle squarely with the screen, so that the front surfaces of the foglamps are 7.62 m (25 ft) from the aiming screen.
2. Ensure that all vehicle components are properly installed, if other work has been performed on the vehicle.
3. Ensure that the vehicle has ½ tank of fuel or less.
4. Close all of the vehicle doors.
5. Rock the vehicle to stabilize the suspension.



6. Adjust the height of the horizontal tape line on the aiming screen so that the distance between the line and the floor is 101.6 mm (4 in) LESS than the distance between the floor and the horizontal centerline of the front foglamps.
7. Turn on the front foglamps, and block the light from the headlamps, if necessary.

Important: The top edge of the high intensity zones must be at or below the level of the horizontal tape line.

8. Observe the top edge of the high intensity zones on the aiming screen.
9. Using the adjusting screws, adjust the foglamps so that the top edge of the high intensity light zone is at or just below the horizontal tape line.