Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you perform the Lighting Systems Diagnostic System Check? | -- | Go to Step 2 | |
2 | Verify that the right low beam headlamp is inoperative. Do the headlamps operate normally? | -- | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
3 |
Does the test lamp illuminate? | -- | Go to Step 5 | Go to Step 4 |
4 | Locate and repair the open, high resistance or short to ground in the right headlamp low beam supply voltage circuit. Refer to Wiring Repairs in Wiring Systems. Is the repair complete? | -- | Go to Step 8 | -- |
5 | Connect a test lamp between the right headlamp low beam supply voltage circuit and CKT 525 (YEL) at the bulb connector. Refer to Circuit Testing in Wiring Systems. Does the test lamp illuminate? | -- | Go to Step 7 | Go to Step 6 |
6 | Locate and repair an open or high resistance in CKT 525 (YEL). Refer to Wiring Repairs in Wiring Systems. Is the repair complete? | -- | Go to Step 8 | -- |
7 | Replace the right headlamp low beam bulb. Refer to Headlamp Replacement . Is the repair complete? | -- | Go to Step 8 | -- |
8 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK | Go to Step 3 |
