Circuit Description
The body control module (BCM) monitors the door key switch circuit for the content theft system. The BCM supplies battery voltage to the switch circuit. When a key is turned in either the LH or RH door lock cylinder, the door key switch is activated which pulls the door key switch circuit low. When detected by the BCM, it will disarm the content theft system or cancel a CTD alarm.
Conditions for Setting the DTC
| • | When the door key switch circuit is shorted to ground for approximately 3 minutes. |
| • | The system voltage must be between 9.0-16.0 volts. |
Action Taken When the DTC Sets
If the short to ground occurs after the vehicle is secured, the content theft system will be disarmed.
If the short to ground occurs before the vehicle is secured, the content theft system will not arm.
Conditions for Clearing the MIL/DTC
| • | The current DTC will clear immediately after the short to ground is corrected. |
| • | A history DTC will clear after 100 consecutive ignition cycles without a fault present. |
| • | Use a scan tool in order to clear history DTCs immediately. |
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you perform the Theft Deterrent Diagnostic System Check? | -- | Go to Step 2 | |
2 |
Does the scan tool display INACTIVE? | -- | Go to Step 3 | Go to Step 4 |
3 |
Does the door key switch parameter change state? | -- | Go to 303631 in Wiring Systems | Go to Step 4 |
4 |
Does the scan tool display INACTIVE? | -- | Go to Step 8 | Go to Step 5 |
5 |
Does the scan tool display INACTIVE? | -- | Go to Step 9 | Go to Step 6 |
6 | Test the signal circuit of the door jamb switch (mini wedge) for a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 13 | Go to Step 7 |
7 | Inspect for poor connections at the harness connector of the BCM. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 13 | Go to Step 10 |
8 | Inspect for poor connections at the harness connector of the LF door jamb switch (mini wedge) . Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 13 | Go to Step 11 |
9 | Inspect for poor connections at the harness connector of the RF door jamb switch (mini wedge) . Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 13 | Go to Step 12 |
10 |
Did you complete the replacement? | -- | Go to Step 13 | -- |
11 | Replace the LF door jamb switch (mini wedge). Did you complete the replacement? | -- | Go to Step 13 | -- |
12 | Replace the RF door jamb switch (mini wedge). Did you complete the replacement? | -- | Go to Step 13 | -- |
13 |
Does the DTC reset? | -- | Go to Step 2 | System OK |
