For 1990-2009 cars only
- Install the wave washer (1) onto the steering shaft assembly.
- If you are installing the existing coil, center the coil first. Refer to Inflatable Restraint Coil Centering - Off Vehicle .
- Align the inflatable restraint steering wheel module coil (4) with the horn tower on the turn signal cancel cam assembly (1).
- Slide the inflatable restraint steering wheel module coil (4) onto the steering shaft assembly.
- Firmly seat the retaining ring (3) into the groove on the steering shaft assembly.
- Remove the centering tab from the new inflatable restraint steering wheel module coil (4).
- Discard the centering tab.
- Attach the wire harness assembly to the steering column with new wire harness straps (1).
- Install the upper and lower trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle .
- Enable the inflatable restraint steering wheel module. Refer to Enabling the SIR System in SIR.
Important: A new inflatable restraint steering wheel module coil will be pre-centered. Do not remove the centering tab from the inflatable restraint steering wheel module coil until the installation is complete.
Caution: Improper routing of the wire harness assembly may damage the inflatable restraint steering wheel module coil. This may result in a malfunction of the coil, which may cause personal injury.
