Removal Procedure
Important: Observe and mark the positions of all the driveline components, relative
to the propeller shaft and the axles, prior to disassembly. These components
include the propeller shafts, drive axles, pinion flanges, output shafts,
etc. Reassemble all the components in the exact places in which you removed
the parts. Follow any specifications, torque values, and any measurements
made prior to disassembly.
- Remove the drive pinion yoke/flange. Refer to
Drive Pinion Yoke Replacement
.
- Remove the pinion oil seal. Use a suitable seal removal tool.
Do not damage the carrier.
- Inspect the seal surface of the pinion yoke/flange for the following
conditions:
• | Damage such as a groove worn by the seal |
- Inspect the carrier bore for burrs that may cause leaks around
the outside of the seal.
Installation Procedure
Tools Required
J 23911 Pinion
Oil Seal Installer
- Install a new pinion
oil seal using theJ 23911
.
- Install the drive pinion yoke/flange. Refer to
Drive Pinion Yoke Replacement
.