Other than checking for a worn grommet and loose electrical connectors, the only service possible is a unit replacement if the diagnosis shows a malfunctioning MAP sensor.

Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

1. Disconnect the negative battery cable.



2. Remove the electrical connector releasing the locking tab.




Important: After removing the MAP sensor from the intake manifold, replace the MAP sensor to intake manifold grommet.

3. Remove the MAP sensor.
4. Remove the MAP sensor grommet.
5. Discard the MAP sensor grommet.

1. Install the new MAP sensor grommet on the MAP sensor.



2. Install the MAP sensor.



3. Install the electrical connector.
4. Connect the negative battery cable.