For 1990-2009 cars only
Aligning Sheet Metal
- Start alignments at the fenders where the fenders meet the front edge of the doors. Work towards the front of the vehicle.
- Align the rear edge of the fender to within 4-6 mm (0.16-0.24 in). Ensure that the fender is parallel to the door.
- Align each side of the fender to within 4-6 mm (0.16-0.24 in).
- You may need to adjust the front end sheet metal as a unit under the following conditions:
| • | The hood is difficult to center. |
| • | The hood is out of square. |
Adjustment Procedure
- Loosen the radiator support bolts.
- Lightly push the sheet metal into the proper position.
- Tighten the radiator support bolts.
