Customer comments of rattles in the door on 1988-89 L and/or W cars may be the result of loose lock rods in the anti-rattle clips. To correct this condition revised anti-rattle clips should be installed (three anti-rattle clips on coupes, two anti-rattle clips on sedan front per door).
Single anti-rattle clip, P/N 16608794 - one required per front door for coupe and sedan.
Double anti-rattle clip, P/N 16609594- two required for coupe, one required for sedan per front door.
Parts are currently available from GMSPO.
1. Remove trim panel.
2. Remove water deflector to access lock rods.
3. With rods disengaged from anti-rattle clips, grasp clip with pliers and rotate 90 degrees to disengage.
4. Install new anti-rattle clips, reinstall rods.
5. Reinstall water deflector.
6. Reinstall trim panel.
Labor Operation Number: L Car RH T1574 Labor Time: .6 Hours LH T1575 .6 Hours
General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.