INADEQUATE CUSHION LEG SUPPORT INSTALL SPACER UNDER SEAT

VEHICLES AFFECTED: EARLY 1987 CORSICA, TEMPEST AND BERETTA WITH TWO WAY SEAT ADJUSTER

Owners of some early Corsica, Tempest and Berettas with 2 way seat adjusters may comments of inadequate leg (thigh) support.

To repair this condition a 12.7mm spacer, P/N 20047408 is to be placed between the front leg of the 2 way seat adjuster on top of the carpet for both passenger and driver seats. When this spacer is used a longer bolt, P/N 10082035 is to be used in place of original bolt.

1. Move seat to rear most position. 2. Remove front adjuster to floor pan bolt. 3. Place 12.7mm spacer, P/N 20047408 between floor pan and adjuster. 4. Install new bolt, P/N 10082035, through adjuster spacer and into floor pan, torque 30-38Nm.

Perform procedure on both front seats.

Use the most applicable labour operation from the Canadian Labour Time Guide and claim as follows:

.2 Hours Shim 1 Seat

.3 Hours Both Right and Left Seats

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.