GM Service Manual Online
For 1990-2009 cars only

Circuit Description

The engine control module (ECM) controls most components with electronic switches which complete a ground circuit when turned ON. These switches are arranged in groups of 4 and 7, and they are called either a surface mounted quad driver module, which can independently control up to 4 output terminals or an output driver module (ODM), which can independently control up to 7 outputs. Not all of the outputs are always used.

Drivers are fault protected. If a relay or solenoid is shorted, having very low or 0 resistance, or if the control side of the circuit is shorted to voltage, it would allow too much current flow into the ECM. The driver senses this and the output is either turned OFF or its internal resistance increases to limit current flow and protect the ECM and driver. The result is high output terminal voltage when it should be low. If the circuit from B+ to the component or the component is open, or the control side of the circuit is shorted to ground, terminal voltage will be low. Either of these conditions is considered to be a driver fault.

Drivers also have a fault line to indicate the presence of a current fault to the ECM's central processor. A scan tool displays the status of the driver fault lines as 0=OK and 1=Fault.

Diagnostic Aids

The scan tool has the ability to command certain components and functions ON and OFF. If a component or function does not have this capability, operate the vehicle during its normal function criteria to inspect for an open or shorted circuit. An open or short to ground will appear in the open positions on the scan tool only when it is not commanded by the ECM or the scan tool, while a short to voltage will appear in the short positions on the scan tool only while the component is being commanded by the ECM or scan tool.

Step

Action

Yes

No

1

Perform a Diagnostic System Check.

Is the check complete?

Go to Step 2

Go to Diagnostic System Check - Engine Controls

2

Install the scan tool.

Is there a number  1,=fault, below any of the numbered positions in the OUTPUT DRIVERS?

Go to Step 3

Go to Step 4

3

Inspect for an open or shorted circuit in any corresponding position, or circuit, that contained a number 1 and repair as necessary.

Is a repair necessary?

Go to Step 9

Go to Step 7

4

Command the output being inspected with a scan tool while watching the corresponding position for each circuit.

Do any of the positions change to a 1?

Go to Step 6

Go to Step 5

5

Command the output being inspected with a scan tool while watching the corresponding position for each circuit.

Does the component or function operate when commanded?

Go to Step 9

Go to the appropriate component table for repair

6

Repair the short to voltage in the corresponding circuit for the position, or circuit, that displayed a 1.

Did you complete the repair?

Go to Step 9

--

7

Disconnect the electrical connector to the component connected to the fault circuit.

Is a 1 still displayed in the corresponding OUTPUT DRIVER position?

Go to Step 8

Go to the appropriate component table for repair

8

Replace the engine control module (ECM). Refer to Engine Control Module Replacement .

Did you complete the replacement?

Go to Step 9

--

9

Operate the vehicle within the conditions under which the original symptom was noted.

Does the system now operate properly?

System OK

Go to Step 2