Tools Required

1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
2. Remove the valve rocker cover. Refer to Valve Rocker Arm Cover Replacement - Left Side or Valve Rocker Arm Cover Replacement - Right Side .
3. Remove the spark plug. Refer to Spark Plug Replacement in Engine Controls-3.4L.
4. Remove the rocker arm. Refer to Valve Rocker Arm and Push Rod Replacement .
5. Install the J 22794 to the spark plug port.
6. Apply compressed air in order to hold the valves in place.
7. Compress the valve spring. Use the J 5892-D or the J 38606 .
8. Measure the following items:

•	The valve locks

•	The valve cap

•	The valve spring




9. Remove the valve stem oil seal.

1. Install the valve stem oil seal. Use the plastic sleeve provided. Press the oil seal over the valve guide boss.



2. Assemble the following items:

•	The spring seat

•	The valve spring

•	The valve cap

3. Compress the valve spring. Use the J 38606 or the J 5892-D .
4. Install the valve locks. Hold the valve locks in place with grease if needed.
5. Release the valve spring. Ensure that the valve locks are seated.
6. Install the spark plug. Refer to Spark Plug Replacement in Engine Controls-3.4L.
7. Install the rocker arm. Refer to Valve Rocker Arm and Push Rod Replacement .
8. Install the valve rocker cover. Refer to Valve Rocker Arm Cover Replacement - Left Side or Valve Rocker Arm Cover Replacement - Right Side .
9. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.