For 1990-2009 cars only
Removal Procedure
- Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
- Drain and recover the coolant.
- Remove the air cleaner assembly.
- Disconnect the radiator hose and electrical connectors from housing.
- Remove the heater hose from the coolant outlet housing (1).
- Remove the bolt which retains the power steering pump and set the bolt aside.
- Remove the coolant outlet housing bolts.
- Remove the coolant housing.
- Remove the gasket.
Refer to Cooling System Draining and Filling .
| 5.1. | Remove the exhaust heat shield. |
| 5.2. | Remove the nut from the exhaust manifold. |
Installation Procedure
- Install the coolant outlet housing (1).
- Install the gasket.
- Install the coolant outlet housing bolts.
- Install the bolt which retains the power steering pump.
- Install the heater hose from the coolant outlet housing.
- Connect the radiator hose and the electrical connectors to the housing.
- Install the air cleaner assembly.
- Refill the cooling system. Refer to Cooling System Draining and Filling .
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
- Inspect the system for leaks.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the coolant outlet bolts to 26 N·m
(19 lb ft).
| 5.1. | Install the exhaust heat shield. |
| 5.2. | Install the nut to the exhaust manifold. |
