GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Remove the door trim panel. Refer to cell-id="11499">Trim Panel Replacement - Side Front Door> or cell-id="11499">Trim Panel Replacement - Side Front Door> .
  2. Remove the water deflector.

  3. Object Number: 276408  Size: SH
  4. Remove the door check link to the hinge pillar bolt (1).
  5. Remove the door check link grommet (3).
  6. Remove the door check link to the door nuts.
  7. Remove the door check link (1) from the vehicle.

Installation Procedure


    Object Number: 276408  Size: SH

    Important: The letters R and L are molded into the check link arm. If you are installing on the right side, the letter R must face up; if you are installing on the left side, the letter L must face up.

  1. Install the door check link (1) to the vehicle.
  2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the door check link to the door nuts.
  4. Tighten
    Tighten the nut to 10 N·m (89 lb in).

  5. Install the door check link grommet (3).
  6. Install the door check link to the hinge pillar bolt.
  7. Tighten
    Tighten the bolt to 9 N·m (80 lb in).

  8. Install the water deflector. Refer to cell-id="11749">Water Deflector Replacement - Front Door> .
  9. Install the door trim panel. Refer to cell-id="11499">Trim Panel Replacement - Side Front Door> or cell-id="11499">Trim Panel Replacement - Side Front Door> .