Front Fender Ornament Replacement. Cadillac XLR 2009

For 1990-2009 cars only

Makes 🢒 Cadillac 🢒 2009 🢒 XLR 🢒 Body Hardware and Trim 🢒 Exterior Trim 🢒 Front Fender Ornament Replacement

Front Fender Ornament Replacement XLR-V

Callout	Component Name
1	Front Fender Ornament Assembly Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section. Procedure Use a J 25070 Heat Gun or equivalent to assist in the removal of the old fender ornament adhesive tape. Gently pry the top of the ornament outward working downward to the bottom of the ornament. Clean all adhesive from the fender panel and wipe the surface dry with a clean lint-free towel prior to installing the new fender ornament. The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to develop sufficient bond strength. When removing protective liners from the adhesive tape, be careful not to touch tape with hands and do not allow tape to come in contact with dirt or any foreign matter prior to adhesion. Align the two center fender ornament alignment pins to the center holes in the fender panel. Using the palm of the hand, wet out the adhesive tape to the entire periphery of the fender panel ornament to ensure full adhesion of the fender ornament to panel is made. Special Tools J 25070 Heat Gun

Callout

Component Name

Front Fender Ornament Assembly

Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section.

Use a J 25070 Heat Gun or equivalent to assist in the removal of the old fender ornament adhesive tape.
Gently pry the top of the ornament outward working downward to the bottom of the ornament.
Clean all adhesive from the fender panel and wipe the surface dry with a clean lint-free towel prior to installing the new fender ornament.
The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to develop sufficient bond strength.
When removing protective liners from the adhesive tape, be careful not to touch tape with hands and do not allow tape to come in contact with dirt or any foreign matter prior to adhesion.
Align the two center fender ornament alignment pins to the center holes in the fender panel.
Using the palm of the hand, wet out the adhesive tape to the entire periphery of the fender panel ornament to ensure full adhesion of the fender ornament to panel is made.

J 25070 Heat Gun