Tools Required

1. Remove the powertrain. Refer to Powertrain Removal and Installation .



2. Remove the driveline support assembly. Refer to Driveline Support Assembly Replacement .
3. Remove the intake manifold. Refer to Intake Manifold Replacement .



4. Install the EN 46326 .
5. Remove the engine flywheel bolts.
6. Remove the flywheel and the reinforcement.
7. Clean and inspect the engine flywheel. Refer to Engine Flywheel Cleaning and Inspection .

1. Apply sealant to the flywheel mounting bolts. Refer to Adhesives, Fluids, Lubricants, and Sealers for the correct part number.



2. Position the flywheel and the reinforcement to the crankshaft.

Notice: Refer to Fastener Notice in the Preface section.

3. Install the flywheel mounting bolts.

Tighten

1. Tighten the flywheel mounting bolts a first pass to 30 N·m (22 lb ft).
2. Tighten the flywheel mounting bolts a final pass an additional 50 degrees using the J 45059 .



4. Remove the EN 46326 .
5. Install the intake manifold. Refer to Intake Manifold Replacement .
6. Install the driveline support assembly. Refer to Driveline Support Assembly Replacement .
7. Install the powertrain. Refer to Powertrain Removal and Installation .