GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2006 🢒 XLR 🢒 Accessories 🢒 Entertainment 🢒 Digital Radio Antenna Cable Replacement

Removal Procedure

    Object Number: 1718849 Size: SH
  1. Loosen the cloth cover in the trunk area that covers the digital radio receiver to access the antenna cable connectors.
  2. Cut the ends off on the antenna cable at the digital receiver.
  3. Remove the right front IP closeout panel. Refer to Instrument Panel Insulator Panel Replacement - Right Side .
  4. Remove the right front carpet retainer. Refer to Carpet Retainer Replacement .
  5. Loosen the right side door manual release lever and leave it to the side. Refer to Front Side Door Inside Handle Cable Replacement .
  6. Remove the right side lock pillar trim. Refer to Body Lock Pillar Trim Panel Replacement .

    7. Object Number: 1718847 Size: SH
  7. Return to the right underside of the IP and look for the harness going through the plastic seal in the pillar to door pass-through. Pull the seal back and locate the connector for the digital antenna. Disconnect it and cut the body side connector off.
  8. Remove the left front carpet retainer. Refer to Carpet Retainer Replacement .
  9. Remove the parking brake assembly. Refer to Parking Brake Lever Pedal Assembly Replacement .

    10. Object Number: 1718845 Size: SH
  10. Under the left side of the IP look for the harness going through the plastic seal in pillar to door pass-through. Pull the seal back and locate the connector for the digital antenna. Disconnect it and cut the body side connector off.

Installation Procedure
  1. Move to the center of the IP area and route a piece of mechanic's wire behind the IP/center console area. Attach the left side of the new antenna cable to the mechanic's wire on the right side of the IP with a piece of tape and pull the wire through the IP/center console area to the left side of the IP. Follow the approximate routing of the old antenna cable when placing the mechanic's wire.

    2. Object Number: 1718845 Size: SH
  2. Push the new connector through the plastic seal on the left side pillar to door pass-through, reconnect the connector, and reinstall the plastic seal. The seal should snap into place securely. Use tie straps as needed to secure the new antenna cable under left side of dash.

    3. Object Number: 1718847 Size: SH
  3. Push the new connector through the plastic seal on the right IP pillar to door pass-through, reconnect the connector, and reinstall the plastic seal. The seal should snap into place securely. Use tie straps as needed to secure the new antenna cable under the right side of dash.

    4. Object Number: 1718852 Size: SH
  4. Route the new antenna cable along the left side of the body following the approximate routing of old antenna cable behind the carpets and back to the digital receiver. Use tie straps as needed to secure the new cable. Reconnect the antenna cable to the digital receiver.
  5. Install the parking brake assembly. Refer to Parking Brake Lever Pedal Assembly Replacement .
  6. Install the left front carpet retainer. Refer to Carpet Retainer Replacement .
  7. Install the right side lock pillar trim. Refer to Body Lock Pillar Trim Panel Replacement .
  8. Install the right front carpet retainer. Refer to Carpet Retainer Replacement .
  9. Install the right side door manual release lever. Refer to Front Side Door Inside Handle Cable Replacement .
  10. Install the right side IP closeout panel. Refer to Instrument Panel Insulator Panel Replacement - Right Side .