Circuit Description
The front fog lamp switch signal circuit is grounded momentarily by pressing the front fog lamp switch. The BCM energizes the front fog lamp relay by applying battery positive voltage to the front fog lamps relay control circuit when the front fog lamp relay is energized, battery positive voltage is applied to the front fog lamps supply voltage circuit which illuminates the front fog lamps.
Conditions for Running the DTC
The battery voltage must be between 9.0-16.0 volts.
Conditions for Setting the DTC
| • | DTC B2530 02 The front fog lamp relay control circuit is shorted to ground. |
| • | DTC B2530 05 The front fog lamp relay control circuit is shorted to battery positive voltage or open. |
Action Taken When the DTC Sets
| • | DTC B2530 02 the front fog lamps will not operate. |
| • | DTC B2530 05 the front fog lamps and the fog lamp indicator will be on at all times or will not operate. |
The front fog lamps will not operate or will remain always on.
Conditions for Clearing the DTC
| • | This DTC will clear on current status after the condition for setting the fault is corrected. |
| • | A history DTC will clear after 100 consecutive ignition cycles without a fault present. |
| • | History and current DTCs can be cleared using a scan tool. |
Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Fog Lights Schematics Connector End View Reference: Master Electrical Component List in Wiring Systems | |||
1 | Did you perform the Diagnostic System Check? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
2 |
Do the front fog lamps turn ON and OFF? | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
3 | Is DTC B2530 02 present? | Go to Step 4 | Go to Step 6 |
4 |
Does the test lamp illuminate? | Go to Step 5 | Go to Step 13 |
5 | Test for a short to ground in the front fog lamp relay control circuit. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 14 | Go to Step 8 |
6 |
Does the test lamp illuminate? | Go to Step 7 | Go to Step 10 |
7 | Test for a short to battery positive voltage in the front fog lamp relay control circuit. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 14 | Go to Step 9 |
8 |
Does the test lamp illuminate? | Go to Step 12 | Go to Step 11 |
9 |
Does the test lamp illuminate? | Go to Step 12 | Go to Step 11 |
10 | Test for a poor connection or an open in the front fog lamp relay control circuit. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 14 | Go to Step 13 |
11 | Replace the front fog lamp relay. Refer to Relay Replacement in Wiring Systems. Did you complete the replacement? | Go to Step 14 | -- |
12 | Replace the underhood electrical center. Refer to Underhood Electrical Center or Junction Block Replacement in Wiring Systems. Did you complete the replacement? | Go to Step 14 | -- |
13 |
Important: After replacing the BCM, perform the setup procedure. Refer to Body Control Module (BCM) Programming/RPO Configuration in Computer/Integrating Systems. Replace the BCM. Refer to Body Control Module Replacement in Computer/Integrating Systems. Did you complete the replacement? | Go to Step 14 | -- |
14 |
Does the DTC reset? | Go to Step 2 | System OK |
