Circuit Description
The steering column module determines the telescoping position of the steering column based on the following factors:
| • | Inputs received from the Telescope Position Sensor that is built into the Telescope Actuator |
| • | The Telescoping Actuator |
The Steering column module supplies a 5-volt reference and a ground to the Telescoping Position Sensor while also monitoring the column position from the telescope position signal circuit.
Conditions for Running the DTC
DTC B1327 is not set as current.
Conditions for Setting the DTC
This DTC sets as current when the voltage at the Steering Column Telescope Motor Signal is less than 0.12 volts for 2 seconds on the telescoping circuit.
Action Taken When the DTC Sets
The steering column module will not allow the affected motor to work during memory recall or easy exit operations. However, the motor will still operate during manual switch positioning.
Conditions for Clearing the DTC
| • | This DTC will clear from current status when the voltage is greater than 0.12 volts for 2 seconds. |
| • | Use a scan tool. |
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you perform the Tilt/Telescoping Steering Column Diagnostic System Check? | -- | Go to Step 2 | Go to Diagnostic System Check - Steering Wheel and Column - Tilt |
2 |
Is the voltage greater than the specified parameter? | 0.12 V | Go to Step 8 | Go to Step 3 |
3 |
Does the DMM indicate the voltage is greater than the specified value? | 4.8 V | Go to Step 4 | Go to Step 6 |
4 | Inspect for poor connections at the harness connector of the telescope actuator. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 7 | Go to Step 5 |
5 |
Important:: Perform the set up procedure for the steering column module. Replace the telescope actuator. Refer to Telescope Actuator Assembly Replacement - On Vehicle . Did you complete the replacement? | -- | Go to Step 7 | -- |
6 |
Important:: Perform the set up procedure for the steering column module. Replace the steering column module. Refer to Steering Column Control Module Replacement . Did you complete the replacement? | -- | Go to Step 7 | -- |
7 | Perform the Steering Column Control Module Programming. Refer to Steering Column Control Module Programming Did you complete the action? | -- | Go to Step 8 | -- |
8 |
Does the DTC reset? | -- | Go to Step 2 | System OK |
