Circuit Description
The steering column module provides a 5 volt reference voltage to the tilt position sensor circuit and the telescope position sensor circuit. The steering column module has a designated circuit that monitors the 5 volt reference voltage.
Conditions for Running the DTC
The steering column module is ON.
Conditions for Setting the DTC
The DTC will set as current when the voltage is out of the range of 4.6 volts to 5.2 volts for 1.2 seconds.
Action Taken When the DTC Sets
Memory recall functions for the steering column module will be disabled.
Conditions for Clearing the DTC
| • | The DTC will clear from the current status when the voltage is within the range of 4.6 volts to 5.2 volts for 1.2 seconds |
| • | Use a scan tool. |
Step | Action | Yes | No |
|---|---|---|---|
1 | Did you perform the Tilt/Telescoping Steering Column Diagnostic System Check? | Go to Step 2 | Go to Diagnostic System Check - Steering Wheel and Column - Tilt |
2 |
Important:: Perform the set up procedure for the steering column module Replace the tilt/telescoping steering column control module Refer to Tilt/Telescope Steering Column Module Replacement. Did you complete the replacement? | System OK | -- |
