Test Description
The number(s) below refer to the step number(s) on the diagnostic table.
-
Lack of communication may be due to a partial malfunction of the class 2 serial data circuit or due to a total malfunction of the class 2 serial data circuit. The specified procedure will determine the particular condition.
-
Checks for DTCs for each module of the system.
-
The presence of DTCs which begin with "U" indicate some other module is not communicating. The specified procedure will compile all the available information before tests are performed.
Step | Action | Yes | No | ||||
|---|---|---|---|---|---|---|---|
Schematic Reference: Navigation System Schematics | |||||||
1 | Install a scan tool. Does the scan tool power up? | Go to Step 2 | Go to Scan Tool Does Not Power Up in Data Link Communications | ||||
Does the scan tool communicate with the control modules? | Go to Step 3 | Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications | |||||
Select the display DTCs function on the scan tool for the following control modules:
Does the scan tool display any DTCs? | Go to Step 4 | ||||||
Does the scan tool display any DTCs which begin with a "U"? | Go to Step 5 | Go to Step 6 | |||||
5 | Does the scan tool display U2150, U2151 or U2153? | Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications | |||||
6 | Does the scan tool display DTC B1000, B1004, B1007, or B1009? | Go to Diagnostic Trouble Code (DTC) List in Body Control System | Go to Step 7 | ||||
7 | Does the scan tool display DTC B1327 or B1328? | Go to Diagnostic Trouble Code (DTC) List in Engine Electrical | |||||
